Do Burton boards come with hardware?

Do Burton bindings come with hardware & screws? Burton bindings come with necessary hardware and screws. Burton bindings come with top four screws or washers. However, the inserts come with the Burton board.

How many screws do I need for snowboard bindings?

Four screws
Four screws are used to mount each binding.

What bindings work with Burton 3d?

Bindings from Flow, Ride, K2, Forum will work the 3-D Hole Pattern and in most cases come with a compatible disc. If you have a different brand you want to use with a Burton board and don’t know if it will work, you can contact us for help or call the manufacturer for a compatible disc.

Do Burton bindings come with screws?

Burton bindings come with top four screws or washers. However, the inserts come with the Burton board. It also comes with disks that are necessary for positioning the angle. Hardware and screws also vary in the case of different versions of Burton bindings.

Do Burton channel inserts come with board?

The inserts are supplied with the board, the binders will have screws in the box. If you don’t have either you got screwed by both stores.

What angle should my snowboard bindings be set at?

If you want to set up your snowboard bindings correctly, your stance on a snowboard should be about shoulder width, with approximately 15 degrees of angle on your front binding and around 0 degrees in the back. Experiment and find what’s most comfortable for you, in the end it’s individual preference.

Can you mix Burton snowboard bindings?

If you mix Burton bindings (3×3 holes), with a non-Burton snowboard (4×4 holes) you may need a special plate that comes in the box with Burton bindings. Burton uses a 3-hole pattern, while other brands use a 4 hole pattern. The plate will make sure your gear will mount correctly. Measure your stance width.

How do I know if my boot-binding will work with Burton?

Check for boot-binding compatibility. If you mix Burton bindings (3×3 holes), with a non-Burton snowboard (4×4 holes) you may need a special plate that comes in the box with Burton bindings. Burton uses a 3-hole pattern, while other brands use a 4 hole pattern. The plate will make sure your gear will mount correctly.

Where to mount the binding on a snowboard?

You usually will mount the binding to the inserts in the center of the row, unless you are planning to ride in a big snow. Then you will have to move the binding one or 2 rows back to allow a better floating. Do not move them back if you are riding on the slopes, it will ruin your balance.

What tools do I need to mount my bindings to boots?

If you have questions about binding / board compatibility, ask an REI sales specialist. For most boards you need only a #3 Phillips screwdriver to mount the bindings and a wrench to fit the bindings to your boots. For quick adjustments on the mountain, you can use a multi-tool.