Why did my wood burner explode?

When an explosion happens inside a wood-burning stove, back drafting is usually to blame. Back drafting is the reverse flow of exhaust in the flue. When installing or inheriting a wood stove, have a chimney expert take a look at your flue and provide you with best practices for taking care of the stove.

What happens if wood stove gets too hot?

What Happens If A Wood Stove Gets Too Hot? A wood burning stove that is too hot can cause metal components to become permanently damaged through warping, weakening or cracking.

Is it safe to leave a wood stove burning overnight?

Yes, you can leave a wood burning stove on overnight. I have done this many times as have other people I know. However, you need to be careful about ventilation. Typically, if you are leaving a wood burning stove on overnight, you will close off both the air intake and the flue, so that the wood burns very slowly.

Can log burner explode?

It happens smoke builds up in the firebox then ignites causing an explosion. Vermont castings are pretty prone to this problem. And if you have been using your ash drawer to start fires for ten years you are very lucky you havnt damaged your stove. Most people cause cracking by doing that pretty quickly.

Why does my fire explode?

When wood in a fire gets hot enough, the cellulose inside starts to turn into gas. As wood burns, the mix of expanding gases and cellulose breaking down makes the pockets of trapped steam burst open from the wood, one by one. This is why you hear the crackling and popping noises.

Why does my wood stove backfire?

Back-puffing and creosote build-up in a stove indicate that the fire produces smoke faster than the chimney draft pulls it out of the stove. Back-puffing happens when the smoke becomes dense enough to ignite in the firebox. If it cools off before it gets to the top of the chimney, there’s less reason for it to rise.

At what temp does creosote ignite?

Creosote is highly combustible and is well known for its fire threat in chimneys of wood-burning fireplaces. Creosote’s flash point (the lowest temperature at which vapors will ignite when given an ignition source like a spark or flame) is surprisingly low at 165-degrees Fahrenheit.

Is 700 degrees too hot for wood stove?

Anything over 800°F is starting to get too hot and could damage your wood stove or fireplace. Some types of wood, if they are let to burn at full force can heat up a fireplace too hot.

Can you leave wood stove door open?

Wood burning stoves are not designed to be used with the door open. You can use a wood burning stove with the door open but doing so will lose the control of the air flow into the stove, making it operate less efficiently and sending more heat up the chimney rather than out into the room.

Can a wood burning fireplace explode?

There is no gas, so no gas can build up in it. It uses wood as fuel, and while wood can be burnt as fuel, wood is not explosive by nature. A wood stove tends to burn the fuel down, and when the fuel is gone, the wood stops heating.

Can my fireplace explode?

Though very rare, gas fireplaces are susceptible to explosions and sudden fires. If the pilot light isn’t sitting properly when the gas begins to flow, gas may build up and explode.

https://www.youtube.com/watch?v=AQ5eGIfADNs