Why do my headlights keep blowing a fuse?

The most common reason for faulty low-beam lights is a blown fuse. Check for melted wires leading to any of the fuses, and replace said fuses if necessary. Use a voltmeter to make sure that power is actually running to your headlight. If not, then the problem is in your wiring.

How many amps should a headlight fuse be?

Your average high beam (for a normal headlight) is 55 or 65 watts. In a 12 V circuit, that’s less than 6 amps nominally. If you put in a 10 amp fuse, you should be ok.

Do headlights run on separate fuses?

Depending on how your headlight circuit is set up, there may be one fuse or multiple fuses for the headlights. If you find a blown fuse, then replacing it may fix the problem. When replacing a blown headlight fuse, it’s important to use a new one with the same amperage rating.

Is there a fuse that controls the headlights?

Most headlight systems are going to involve a fuse, switch, relay, and bulb. This relay is the connection between the battery of your car and your headlights. There are also fuses involved to protect the rest of your electrical system should there be a shortage.

What are the symptoms of a bad headlight relay?

Headlights Don’t Turn On The most common sign of a bad headlight relay is headlights that don’t work. A headlight relay will typically fail in the open position, preventing voltage from reaching the headlights. If the low beam relay fails, the low beams won’t work.

Why does my car keep blowing light bulbs?

There are a few reasons why your car bulbs might have blown: faulty circuits, faulty bulbs, over-current, damaged wiring…

Where is the headlight relay?

Find the headlight relay closure: Usually, it is under the hood of the car. The point where your fuse panel is most likely located. On the other hand, it may also be located inside the cab of the car, this would be the case if your car comes with an interior fuse box.

Can a blown fuse cause headlights to go out?

If a headlight fuse blows, it could cause the headlights to stop working. Most headlight systems are also designed with a relay that switches the power between low beam and high beam headlights. If this relay goes bad, it could allow power to the high beams, but not the low beams.

Where is the headlamp fuse located?

The front of the dash panel has a fuse panel on it.

Where is the relay switch for headlights?

What would cause low beam headlights not to work?

The likely cause is a fuse, headlight relay, headlight switch, dimmer switch or a wiring fault. About the only cause that is an easy fix is a blown fuse. Consult your owner’s manual to locate the main fuse for the headlight circuit and replace that fuse with one having the same amp rating.